Cars’ technical components can effectively cooperate thanks to the accessory belts. The serpentine belt is one of them. Specifically, the tightness of the serpentine belt plays a key role in linking engine components. Whether the engine parts, such as generator, alternator, battery, etc., work effec
Step 1: Park your vehicle and turn off the engine. Step 2: Open the hood and locate the serpentine belt. The belt will be on the front of the engine. Tip: Take a picture of the serpentine belt routing with your cell phone. This will make it easier to reinstall the belt if you do not have a diagram of its routing.
Loosen both bolts, then push the alternator as hard as you can to tension the belt while you tighten the top bolt. Then tighten the other bottom bolt. You can see the guy demonstrating how tight the belt is, at about 3:20 in the video you linked to, but there wasn't a very clear description of how he was judging the tension was correct (and to
The serpentine belt on a Jeep TJ can be replaced by following these steps: 1. Remove the old belt by loosening the tensioner pulley and sliding the belt off. 2. Clean the pulley surfaces and install the new belt. 3. Route the new belt around all the pulleys except the tensioner pulley. 4.

Step #01: Turn on your treadmill and let it run for a few minutes so that the drive belt is hot and loose. Step #02: Locate the tension bolts at either end of the deck and loosen them using an Allen wrench. Step #03: Carefully lift the deck and move it out of the way. You may need help from a friend for this step.

Find parts at
XQcBR5.
  • 0gm9w83zy3.pages.dev/279
  • 0gm9w83zy3.pages.dev/560
  • 0gm9w83zy3.pages.dev/298
  • 0gm9w83zy3.pages.dev/418
  • 0gm9w83zy3.pages.dev/153
  • 0gm9w83zy3.pages.dev/399
  • 0gm9w83zy3.pages.dev/438
  • 0gm9w83zy3.pages.dev/128

    • how tight should a serpentine belt be